With no sampling system to maintain, 1000 cross-duct monitors are easy to install and simple to operate, vital for a plant where there may be little or no technical support available.
The 1000 analyser may be used as a complete stand-alone monitor or as part of an integrated emission monitoring, logging and reporting system. The instrument is particularly suited to large and dirty processes.
Low cost single gas analyzer for small, medium and large Boilers.
Simple installation with only FOUR modules, Transmitter, Receiver, Power supply and Signal Processor, all NEMA 4X rated.
Most suitable for emissions monitoring as well as closed loop online insitu process control with 10 secs response time.
Minimal lens contamination
» High-efficiency air purges to maintain optical efficiency
Automatic on-line zero calibration
» Continual correction using integral reference gas cell
Real-time normalization
» To standard reference conditions
Low maintenance overheads
» Only simple, infrequent checks to windows required
Choice of data presentation
» Ppm, mg/m3 and mg/Nm3
Optional independent verification
» Using certified test cellsor filters
One-year parts & labor warranty for complete peace of mind
|
Summary Specification
Span:
Co & NO selectable from 0-100 ppm to 0-10000 ppm, within the range 200 to 6000 ppm.meter at STP
So2 Selectable from 0-100 ppm to 0-10000 ppm, within the range 200 to 6000 ppm.meter at STP
Display Units: ppm; mg/m3 (measured); mg/Nm3 (normalized)
Accuracy: + 2% of measurement or + 5ppm whichever is greater
Outputs:
| Analog |
4~20mA isolated, 500 ohms max |
| High Alarm |
Volt free contact |
| Data Valid |
Volt free contact (both rated @ 10 Amps @ 250 V) |
Inputs:
| Oxygen |
4~20mA; Temp: 4~20mA; Pressure: 4~20mA |
| Plant Status contact |
Volt free contact |
| Serial Port |
For remote instrument operation, normalizing inputs and outputs |
Path length: 0.5 to 8 meters
Flue gas temperature: 0 to 300 deg C
Construction: Cast Aluminum, fully sealed to IP65
Transmitter: Electrically heated Silicon Nitride Cylinder
Detector: Lithium Tantalite Pyro-electric detector
Ambient temperature limits: -20 deg C to 70 deg C
Power Requirements: 85 to 132/170 to 264 V AC, 50/60 Hz, and 50 VA
Air purge consumption: 1.0 l/s @ 1 bar (compressed air) 5 l/s (blower air)
The range of the output span is quoted in ppm.meter.
|
Call Us: 631-756-9116 